Search found 3 matches

Go to advanced search

Display posts from previous
Sort by

New demo user here...but try using the ID command and select your required reference point using Esnaps. Then use relative co-ordinates with your next command...@Xco-ord,Yco-ord in cartesian or @dist>angle in polar polar. This should start your next command such as line, circle centre etc. at the re...

Fillet & Trim

Hi, I am trying the demo version but can't seem to fillet a line to an ellipse...any suggestions@ Also, drew a simple cube in isometric with an isocicle on easch of the 6 faces. Then tried to trim the rear face isocircles to produce a holed cube effect. However, I could select the front isocircles a...

I have tried a few TRIAL versions of IntelliCAD... CADopia, BricsCAD and CMS. The CMS demo version seems to have the most bugs so far. I have encountered problems saving user defined hatches and displaying attributes(ATTDISP) that are fixed + hidden. I don't know if these problems are particular to ...

Go to advanced search