Hi All,
I hava Intellcad 4+ and I read somewhere in specs that it calculates SECOND MOMENT OF AREA.
1. Is this right?
2. If so what is the command?
Thank you in advance for any help.
ERIC
#2
ERIC,
The command "massprop" can be run on 3D Solids and will give the following information:
Mass: 125.2641
Volume: 125.2641
Bounding Box:
Lower Bound: X= 4.8769 Y= 2.5834 Z= 0.0000
Upper Bound: X= 7.3062 Y= 4.7319 Z= 24.0000
Centroid: X= 6.0916 Y= 3.6577 Z= 12.0000
Moments of inertia: X= 25774.7626 Y= 28760.4946 Z= 6433.8379
Products of inertia:
XY: 2791.0096
YZ: 5498.1218
ZX: 9156.6401
Radii of gyration: X= 14.3445 Y= 15.1525 Z= 7.1667
Principal moments and X-Y-Z directions about centroid:
I: 6060.8634 along X= 1.0000 Y= 0.0000 Z= 0.0000
J: 6074.2803 along X= 0.0000 Y= 1.0000 Z= 0.0000
K: 109.7889 along X= 0.0000 Y= 0.0000 Z= 1.0000
ssc
The command "massprop" can be run on 3D Solids and will give the following information:
Mass: 125.2641
Volume: 125.2641
Bounding Box:
Lower Bound: X= 4.8769 Y= 2.5834 Z= 0.0000
Upper Bound: X= 7.3062 Y= 4.7319 Z= 24.0000
Centroid: X= 6.0916 Y= 3.6577 Z= 12.0000
Moments of inertia: X= 25774.7626 Y= 28760.4946 Z= 6433.8379
Products of inertia:
XY: 2791.0096
YZ: 5498.1218
ZX: 9156.6401
Radii of gyration: X= 14.3445 Y= 15.1525 Z= 7.1667
Principal moments and X-Y-Z directions about centroid:
I: 6060.8634 along X= 1.0000 Y= 0.0000 Z= 0.0000
J: 6074.2803 along X= 0.0000 Y= 1.0000 Z= 0.0000
K: 109.7889 along X= 0.0000 Y= 0.0000 Z= 1.0000
ssc