CAD Software Forum

We normally print all our drawings with a print stamp on the bottom showing the file name and location.
To set this I went to "options" then "print settings" and then "print stamp settings" then enter the style, and it works until I restart the program.
After restarting the program I notice the setting did not take and I have to set it each time I load the program. I am testing the software using the demo version.
Would setting be remembered in the paid version? or am I doing something wrong?

When you exit the print dialogue, are you saving?
ie: 'Apply to Layout'

Steve

Yes, I have tried "applied to layout" and save it as a drawing template, this works only until I exit the program.
When I start the program new, the 'Print Stamp" footer is blank and I have to input the value again.