Page 1 of 1
Posted: Tue Nov 14, 2000 4:43 pm
by dtrotzjr
That is a great site. Thanks for sharing with us. I am sure we can all benefit from your contribution.
Anyone who has not seen this site yet, go check it out there are a few very usefull lisp routines for anyone using IntelliCAD.
------------------
David Trotz
Posted: Tue Jan 09, 2001 11:18 am
by muncie
Thank you for the input. I spent a couple of hours repairing it and adding additional items. I used the path syntax you suggested and it works great.
b
Posted: Tue Jan 09, 2001 4:47 pm
by avaernes
Do the drawings contain solid hatching or pspace viewports?
Posted: Wed Jan 10, 2001 5:07 am
by muncie
avaernes, Thanks for your reply. There are no solid hatches or pspace viewports. The drawing is a very simple small assembly. The problem appears to occur whenever the drawing is saved as a std r14 dwg, but not when saved as r13 or below.
Thanks
muncie
[This message has been edited by muncie (edited 01-10-2001).]
Posted: Wed Jan 10, 2001 10:26 pm
by MTriche
Hello Munci,
Could you send a sample drawing for me to look at? It may help in determining what is going on. Just note on the email that it is for me.
Melodie
cms@etoolbox.com
Posted: Thu Jan 11, 2001 9:31 am
by Kika99
Hello!
I have the same Problems like you. But I noticed that the error occurs even with acad2000.dwg. And the error occurs not every time when you save the drawing. Maybe it belongs to the autosave-function???
