CAD Software Forum

Posted: **Sun Apr 27, 2003 7:22 pm**

What I did is:
1) I draw a ellipse;
2) I offset it;
3) I draw two lines passing though the original ellipse and the offset ellipse;

This question is:
I can trim the original ellipse, but
I cannot trim the offset ellipse.

Posted: **Sat May 17, 2003 5:27 pm**

I can't trim none of the ellipses

Posted: **Mon May 19, 2003 8:26 am**

1.- In Menu "Settings/Drawing Settings" palet "Entity Creation" choose in "change setting for " Ellipse and click in "Create Ellipses as Polylines".

2.- Redraw ellipses and offset.

3.- trim Ellipses

CAD Software Forum

Offset ellipse problem

Offset ellipse problem