CAD Software Forum

I have an odd issue when trying to add dimensions in my drawing. Sometimes the dimensioning appears to be fine until I hit enter to place the dimension. The dimension disappears. I can try over and over and for some reason the dimension won't stay. I get the following error in the command line:

ENTER to select entity/<Origin of first extension line>: 56'-4 3/32",-2'-9 35/64"
Origin of second extension line: 60'-4 11/64",-2'-9 35/64"
[Angle/Mtext/Text/Horizontal/Vertical/Rotated]: 60'-2 5/64",-1'-11 3/4"
Invalid input

I can dimension other points just not the ones I tried when I got the error. This last time I was dimensioning where a line intersects a rectangle. However if I explode the rectangle then I am able to dimension it. Anyone have any thoughts to what would cause the issue?

Thanks,
Sean

Hello!

same issue here with version 11. Did you had any advance on that?


Greetings from Spain

Maybe this helps, i have the same problem but only when i do a dimension on a block, for me the solution was the command DIMUPT and put it on ON