CAD Software Forum

ICAD newbie here, ACAD oldie.

I'm trying to move multiple objects by crossing window selection, but ICAD jumps past "Opposite corner: " prompt.
Here's the command trail:
Command:
_MOVE
[FILter]/<Select entities to move>: cr
First corner of crossing window: 2.640,14.727,0.000
Opposite corner: 2.640,14.727,0.000 <= this is autofilled with first corner coords and entered
[FILter]/<Select entities to move>: <= so no entities are selected

Is there a setvar for picking multiple entities? What am I doing wrong?

Try the same task in another drawing or a new drawing.
It works as usual on my side.
Regards.

QuanNguyen wrote: ↑

Fri Jul 18, 2025 2:54 am

Try the same task in another drawing or a new drawing.
It works as usual on my side. Agario
Regards.

Thank you QuanNguyen, for sharing your experience!