Page 1 of 1
Ray cannot be trimmed
Posted: Tue Aug 23, 2005 1:41 am
by shweta
All the lines drawn by ray command can not be trimmed, we need to draw a second line over writting the ray and delete it later on.
Even it needs to be refreshed all the time to make it visible.
Posted: Tue Aug 23, 2005 8:32 pm
by CW
Same with xlines. New bug in 6. Wait a while. They are pretty good about fixing these things.
[This message has been edited by CW (edited 08-23-2005).]
Posted: Fri Aug 26, 2005 3:00 pm
by John Finlay
All,
I tried to trim a ray and it went ok with a straight line and my ray trimmed another ray.
It did not work trimming to a polyline.
------------------
Regards
John Finlay