CAD Software Forum

Posted: **Thu Jun 07, 2007 9:53 am**

Hi All
I saw a question posted here about boundary command that is not working and I saw no answer.
This command really work? at the end the finishing button are all grayed no matter what actions I do. I tried all options. any suggestions?
the same with the wipeout. We have the latest version, not 6.3.
thanks
Nico

Posted: **Thu Jun 07, 2007 5:12 pm**

nicolino,

At the command prompt type:

-boundary

Then select the center point and a boundary will be created.

Note the minus sign before the command that supresses the dialog box.

------------------
Regards
John Finlay

Posted: **Fri Jun 08, 2007 9:33 pm**

thanks
it works, but this is written in the manual?