C++ compiler
Posted: Fri Dec 01, 2006 2:32 am
What compiler do I need to use with SDS and intellicad?
Thanks
Thanks
CAD Software Forum
Free technical support forum for CMS IntelliCAD and ERP MRP Software
https://www.forums.intellicadms.com/
C++ compiler
Page 1 of 1
Posted: Sat Dec 02, 2006 12:22 am
VS2005 seems to work just fine so far!
Posted: Sat Dec 02, 2006 8:28 am
Delphi 7 works pretty well too, if you like Pascal.
Posted: Sat Dec 02, 2006 5:50 pm
Hi Rick,
I guess SDS is not compiler specific. I wonder when DRX comes out if it will require a specific compiler as ARX does. I have never used Pascal so I wouldn¡¯t no where to start
Dan
I guess SDS is not compiler specific. I wonder when DRX comes out if it will require a specific compiler as ARX does. I have never used Pascal so I wouldn¡¯t no where to start
Dan
Posted: Mon Dec 04, 2006 10:28 am
Daniel,
It will depend what DRX is based on. If it directly exposes the Intellicad C++ classes, then yes, it will probably require a specific compiler (I'm guessing VC++).
I was able to write an ARX dll in Delphi up to AutoCAD 14, but enough changed in AutoCAD 2000 and later with the C++ classes that using the Delphi compiler was no longer possible.
I was able to compile an SDS dll with Delphi that runs in CMS Intellicad 5.1 successfully.
Regards,
------------------
Rick Francken
www.franckensoft.com
Custom Software Development
and Design Automation Services
It will depend what DRX is based on. If it directly exposes the Intellicad C++ classes, then yes, it will probably require a specific compiler (I'm guessing VC++).
I was able to write an ARX dll in Delphi up to AutoCAD 14, but enough changed in AutoCAD 2000 and later with the C++ classes that using the Delphi compiler was no longer possible.
I was able to compile an SDS dll with Delphi that runs in CMS Intellicad 5.1 successfully.
Regards,
------------------
Rick Francken
www.franckensoft.com
Custom Software Development
and Design Automation Services