CAD Software Forum

Hello

I am not able to get the following AutoLISP programs to run. These came from the free archives at CADALYST. I have not used AutoLISP before, so I suspect I

am doing something wrong, or there is a problem with my install of IntelliCAD. I'm using IntelliCAD 6.2 PE+, and have also tried them in IntelliCAD 6.1 PE+

Can anyone confirm that these programs work?
http://www.concept-4d.com/spline-to-pline.lsp
;;CADALYST 12/03 AutoLISP Solutions SPLINE-TO-PLINE.LSP
;;(c) 2003 Tony Hotchkiss
http://www.concept-4d.com/Spline2Pline.lsp
;;;CADALYST 06/05 Tip2039: Spline2Pline.lsp Spline to Polyline Conversion (c) Lloyd Beachy
;; Spline2Pline.lsp (c) 2005 Lloyd Beachy


Thanks,
Chris

chrisd,
Both of those lisp programs are written in Visual Lisp, which I believe is not supported in Intellicad.

Thanks for the info.

I found a good stand alone app that will do the conversion, SPLINEDXF at www.caddepot.com .